Glossary entry (derived from question below)
English term or phrase:
wire draw effect
Spanish translation:
efecto de desgaste del orificio
Added to glossary by
Gabriela Galtero
Jun 19, 2015 21:11
9 yrs ago
2 viewers *
English term
wire draw effect
English to Spanish
Tech/Engineering
Mechanics / Mech Engineering
Steam energy / trampas de vapor
The primary reason for wire draw in orifice traps is the incorrect sizing, or misapplication of the trap. The most severe wire draw will occur at extremely high nozzle velocities where there are also liquid droplets (condensate) present. In an orifice steam trap, this condition occurs only when there is primarily steam flow in the nozzle.
Proposed translations
(Spanish)
5 | efecto de desgaste del orificio | slothm |
4 | efecto de trefilado | Wilsonn Perez Reyes |
3 | efecto deformación(trefilado) del lalambre en la trampa de vapor | lugoben |
References
Trampas de vapor | slothm |
Proposed translations
14 hrs
Selected
efecto de desgaste del orificio
El sujeto de la oración no es el alambre sino el orificio.
Una traducción literal puede modificar la idea que se trata de transmitir.
Es que el uso de un alambre limpiador de mayor diámetro provoca desgasste en el diámetro del orificio causando pérdida de vapor activo.
https://www.google.com.uy/url?sa=t&rct=j&q=&esrc=s&source=we...
Para limpiar la boquilla, se remueve la tapa de la misma y se usa un alambredel tamaño del orificio de la boquilla para remover cualquier partícula ...
http://es.patents.com/us-re32989.html
El orificio rodea un alambre que tiene una ...
El uso de un alambre limpiador en el venteador del balde.
https://www.google.com.uy/url?sa=t&rct=j&q=&esrc=s&source=we...
Para limpiar la boquilla, se remueve la tapa de la misma y se usa un alambredel tamaño del orificio de la boquilla para remover cualquier partícula ...
Una traducción literal puede modificar la idea que se trata de transmitir.
Es que el uso de un alambre limpiador de mayor diámetro provoca desgasste en el diámetro del orificio causando pérdida de vapor activo.
https://www.google.com.uy/url?sa=t&rct=j&q=&esrc=s&source=we...
Para limpiar la boquilla, se remueve la tapa de la misma y se usa un alambredel tamaño del orificio de la boquilla para remover cualquier partícula ...
http://es.patents.com/us-re32989.html
El orificio rodea un alambre que tiene una ...
El uso de un alambre limpiador en el venteador del balde.
https://www.google.com.uy/url?sa=t&rct=j&q=&esrc=s&source=we...
Para limpiar la boquilla, se remueve la tapa de la misma y se usa un alambredel tamaño del orificio de la boquilla para remover cualquier partícula ...
4 KudoZ points awarded for this answer.
Comment: "Gracias"
2 hrs
efecto de trefilado
Wire drawing: making steel wire by drawing it through successively smaller round holes in steel blocks called dies
Estructura industrial [COM] Ficha completa
EN
wire drawing
ES
trefilado
Source: InterActive Terminology for Europe
http://iate.europa.eu/SearchByQuery.do
--------------------------
"Wire drawing" es la reducción del diametro de un alambre pasándolo por un dado. Aun con lubricante, el dado se desgasta por fricción. En este caso la válvula representa el dado, y el fluido representa el alambre. Entonces "... menos desgaste en las válvulas debido al efecto de trefilado/estirado de alambre".
http://forum.wordreference.com/threads/wire-draw.2653777/
--------------------------
El estirado con lubricante y el líquido especial para las boquillas en la entrada y la salida de los moldes aseguran un excelente ***efecto de trefilado***.
http://www.etwinternational.com.ar/198391-2-1-take-up-and-pa...
Estructura industrial [COM] Ficha completa
EN
wire drawing
ES
trefilado
Source: InterActive Terminology for Europe
http://iate.europa.eu/SearchByQuery.do
--------------------------
"Wire drawing" es la reducción del diametro de un alambre pasándolo por un dado. Aun con lubricante, el dado se desgasta por fricción. En este caso la válvula representa el dado, y el fluido representa el alambre. Entonces "... menos desgaste en las válvulas debido al efecto de trefilado/estirado de alambre".
http://forum.wordreference.com/threads/wire-draw.2653777/
--------------------------
El estirado con lubricante y el líquido especial para las boquillas en la entrada y la salida de los moldes aseguran un excelente ***efecto de trefilado***.
http://www.etwinternational.com.ar/198391-2-1-take-up-and-pa...
13 hrs
efecto deformación(trefilado) del lalambre en la trampa de vapor
Resumen:
El presente trabajo es un estudio del efecto de la velocidad de deformación en el comportamiento mecánico de los alambres de acero durante el trefilado.
Abstract:
This paper is a study of the strain rate effect on the mechanical behaviour of steel wires during drawing.
www.mater.upm.es/fgalvez/PDF/Gef2002-Tref.pdf
Discussion of Wire Draw Effect in HydroProducts Steam Saver Trap
A major concern of all engineers and facilities managers utilizing a venturi steam trap is the effect of wire draw on the performance of the trap.
In 1994 I installed Steam Saver traps from HydroProducts on four sets of drying cans on Dye Range #4.The objective of the installation was to determine the performance of the Steam Saver traps compared with Armstrong bucket traps that were traditionally used. After 5 years of operation, several of the Steam Saver units were removed during a PM cycle and inspected. There was no change in the internal throat diameter of the traps, even after five years of continuous service.
For a Steam Saver trap, this can only occur as the actual condensate load through the nozzle falls to a small percentage of the design capacity of the trap. On most applications involving Steam Saver traps, the condensate flow rate never falls below 25% of the trap’s maximum capacity. The condensate velocity through the nozzle remains low and there is no significant wire draw effect on the nozzle.
The above dry can application, however, did allow the condensate load to fall to less than 10% of capacity. This occurred for significant periods of time between product runs, and probably approached 40% of the total range operational time. It would be expected that, if wire draw would occur at these same pressures, it would show up in this application. The absence of any change in the wire diameter over the last seven years seems to indicate that for saturated steam at pressures seen in most industrial environments, the ten-year guarantee given by HydroProducts is well founded and probably very conservative, even for less than ideal operating circumstances.
http://www.hydroproductscompany.com/pdf/discussion-of-wire-d...
Conclusión
El efecto de deformación del alambre que ocurre en la boquilla de la trampa venturi, es reducido grandemente por las utilización de rtampas de vapor de Hydroproducts.
El presente trabajo es un estudio del efecto de la velocidad de deformación en el comportamiento mecánico de los alambres de acero durante el trefilado.
Abstract:
This paper is a study of the strain rate effect on the mechanical behaviour of steel wires during drawing.
www.mater.upm.es/fgalvez/PDF/Gef2002-Tref.pdf
Discussion of Wire Draw Effect in HydroProducts Steam Saver Trap
A major concern of all engineers and facilities managers utilizing a venturi steam trap is the effect of wire draw on the performance of the trap.
In 1994 I installed Steam Saver traps from HydroProducts on four sets of drying cans on Dye Range #4.The objective of the installation was to determine the performance of the Steam Saver traps compared with Armstrong bucket traps that were traditionally used. After 5 years of operation, several of the Steam Saver units were removed during a PM cycle and inspected. There was no change in the internal throat diameter of the traps, even after five years of continuous service.
For a Steam Saver trap, this can only occur as the actual condensate load through the nozzle falls to a small percentage of the design capacity of the trap. On most applications involving Steam Saver traps, the condensate flow rate never falls below 25% of the trap’s maximum capacity. The condensate velocity through the nozzle remains low and there is no significant wire draw effect on the nozzle.
The above dry can application, however, did allow the condensate load to fall to less than 10% of capacity. This occurred for significant periods of time between product runs, and probably approached 40% of the total range operational time. It would be expected that, if wire draw would occur at these same pressures, it would show up in this application. The absence of any change in the wire diameter over the last seven years seems to indicate that for saturated steam at pressures seen in most industrial environments, the ten-year guarantee given by HydroProducts is well founded and probably very conservative, even for less than ideal operating circumstances.
http://www.hydroproductscompany.com/pdf/discussion-of-wire-d...
Conclusión
El efecto de deformación del alambre que ocurre en la boquilla de la trampa venturi, es reducido grandemente por las utilización de rtampas de vapor de Hydroproducts.
Reference comments
14 hrs
Reference:
Trampas de vapor
El uso de un alambre limpiador en el venteador del balde.
Para limpiar la boquilla, se remueve la tapa de la misma y se usa un alambredel tamaño del orificio de la boquilla para remover cualquier partícula ...
--------------------------------------------------
Note added at 14 hrs (2015-06-20 11:54:39 GMT)
--------------------------------------------------
Es necesario puntualizar que es el orificio el que pierde en este proceso de limpieza ya que se modifica su tamaño pudiendo provocar pérdida innecesaria de vapor ($$$$$).
Para limpiar la boquilla, se remueve la tapa de la misma y se usa un alambredel tamaño del orificio de la boquilla para remover cualquier partícula ...
--------------------------------------------------
Note added at 14 hrs (2015-06-20 11:54:39 GMT)
--------------------------------------------------
Es necesario puntualizar que es el orificio el que pierde en este proceso de limpieza ya que se modifica su tamaño pudiendo provocar pérdida innecesaria de vapor ($$$$$).
Reference:
Something went wrong...