Glossary entry (derived from question below)
English term or phrase:
wiremap
Spanish translation:
diagrama de cables
Added to glossary by
jmleger
Mar 8, 2004 15:18
20 yrs ago
6 viewers *
English term
wiremap
English to Spanish
Tech/Engineering
Electronics / Elect Eng
electrical/telecom
Tests for wiremap, opens, shorts, miswires, reversals and split pairs
Proposed translations
(Spanish)
5 | diagrama de cables | Monica Castell |
5 | mapeador de cableado | Sergio Aguirre |
Proposed translations
7 mins
Selected
diagrama de cables
Es la traducción que suelo utilizar para mis clientes que se dedican a comprobadores/certificadores de redes de fibra óptica/cobre
4 KudoZ points awarded for this answer.
Comment: "Muchas gracias.
Jean-marie Léger"
22 mins
mapeador de cableado
Probador de cableado
Wiremap
Wiremap is used to identify installation wiring errors. For each of the 8 conductors in the link, wire map should indicate:
Proper pin termination at each end
Continuity to the remote end
Shorts between any two or more conductors
Crossed pairs
Split pairs
Reversed pairs
Shorted pairs
Any other miswires
A reversed pair occurs when the polarity of one wire pair is reversed at one end of the link (also called a tip/ring reversal). A crossed (or transposed) pair occurs when the two conductors in a wire pair are connected to the position for a different pair at the remote connector. Split pairs occur when pin to pin continuity is maintained but physical pairs are separated. Refer to the figure below for an illustration of correct pairing, a reversed pair, crossed pairs, and split pairs.
For fast, comprehensive LAN Wiremap verification.
Whether you're an electrical contractor, a home networking professional, datacom specialist or IT/network manager, Fluke Networks family of powerful Voice/Data/Voice (VDV) verification and troubleshooting tools will allow you to verify your work while delivering a quality installation.
The MicroMapper™ is a small handheld cable tester which enables network professionals to quickly and easily verify the integrity of Ethernet twisted pair cabling.
Wiremap
Wiremap is used to identify installation wiring errors. For each of the 8 conductors in the link, wire map should indicate:
Proper pin termination at each end
Continuity to the remote end
Shorts between any two or more conductors
Crossed pairs
Split pairs
Reversed pairs
Shorted pairs
Any other miswires
A reversed pair occurs when the polarity of one wire pair is reversed at one end of the link (also called a tip/ring reversal). A crossed (or transposed) pair occurs when the two conductors in a wire pair are connected to the position for a different pair at the remote connector. Split pairs occur when pin to pin continuity is maintained but physical pairs are separated. Refer to the figure below for an illustration of correct pairing, a reversed pair, crossed pairs, and split pairs.
For fast, comprehensive LAN Wiremap verification.
Whether you're an electrical contractor, a home networking professional, datacom specialist or IT/network manager, Fluke Networks family of powerful Voice/Data/Voice (VDV) verification and troubleshooting tools will allow you to verify your work while delivering a quality installation.
The MicroMapper™ is a small handheld cable tester which enables network professionals to quickly and easily verify the integrity of Ethernet twisted pair cabling.
Something went wrong...