This question was closed without grading. Reason: Other
Aug 11, 2010 00:33
14 yrs ago
English term
hand off
Not for points
English to French
Tech/Engineering
Engineering: Industrial
For this example, assume a depth of cut equal to approximately 30 percent of the tool diameter. If there are other considerations limiting the load on the tool, follow the lesser one. Make sure the tool creates clear cusps to distinguish one depth from another. The height of the block should accommodate at least 12 depths of cut. The slope on the cutting side should clear the tool holder. The length of the block should be sufficient to hang off the vise to allow at least 10 side passes. The width should be sufficient to be able to see the cuts.
Discussion