cross generator

English to Polish Tech/Engineering Printing & Publishing

Connect the Microdot Generator unit to the video monitor using the double ended BNC connector(s). Connect the coaxial cable(s) from the generator to the monitor.
Connect the camera cables - one end locates in the top of the camera and the other end connects to the corresponding socket at the back of the cross generator unit, i.e. No1. camera is connected to No1. socket. Note that the camera cables are individually numbered.

4) On 4 to 8 camera cross generator units, the power supply cable can now be connected. The socket end connects to the power in on the rear of monitor/ cross generator and the plug ends connect to the rear of the Cross Generator.
When there are only 2 cameras, there is only one power supply cable.

5) Ensure all the units are switched off, then connect the mains plug to the rear of the Cross Generator Unit.

6) Connect the pneumatic supply to the air regulator and set at between 4 - 5 bar.

Instrukcja obsługi urządzenia do montażu fleksograficznych form drukowych jm heaford (Cobra)